|
|
- High density programmable digital POLs
- 3V - 14V Input voltage range
- Programmable feedback loop compensation
- Sequencing and cascade operating modes
- Fully programmable outputs with margin facility
|
 |
|
RoHS lead free and lead-solder-exempt products are available
Wide input voltage range: 3V - 14V
High continuous output current: 15A
Wide programmable output voltage range: 0.5V - 5.5V
Active digital current share
Output voltage margining
Overcurrent and overtemperature protections
Overvoltage and undervoltage protections, and Power Good signal tracking the output voltage setpoint
Programmable power-up delay
Tracking during turn-on and turn-off with guaranteed slew rates
Sequenced and cascaded modes of operation
Single-wire line for frequency synchronization between multiple POLs
Programmable interleave
Programmable feedback loop compensation
Enable control with programmable polarity
Flexible fault management and propagation
Start-up into the load pre-biased up to 100%
Full rated current sink
Real time current and temperature measurements, monitoring, and reporting
Small footprint vertical SMT package: 8 x 32mm
Low profile of 14mm
Compatible with conventional pick-and-place equipment
Wide industrial operating temperature range
UL60950 recognized, CSA C22.2 No. 60950-00 certified, and TUV EN60950-1:2001 certified
|
Applications
Low voltage, high density systems with Intermediate Bus Architectures (IBA)
Point-of-load regulators for high performance DSP, FPGA, ASIC, and microprocessor applications
Industrial computing, servers, and storage
Broadband, networking, optical, and wireless communications systems
Active memory bus terminators
Benefits
Integrates digital power conversion with intelligent power management
Eliminates the need for external power management components and communication bus
Completely programmable via pin strapping and one external resistor
One part that covers all applications
Reduces board space, system cost and complexity, and time to market
|
| Power-One’s point-of-load converters are recommended for use with regulated bus converters in an Intermediate Bus Architecture (IBA). The ZY7115G is an intelligent, fully programmable step-down point-of-load DC-DC module integrating digital power conversion and intelligent power management. The ZY7115G completely eliminates the need for external components for sequencing, tracking, protection, monitoring, and reporting. Performance parameters of the ZY7115G are programmable by pin strapping and external resistor and capacitor and can be changed by a user at any time during product development and service without a need for a communication bus. |
|
|
|
|
|
